What should be paid attention to during the operation of the volute dewatering screw press
Jan 09, 2023
During the working period of the sludge dewatering machine, the operator needs to pay attention to its operation at all times. If any abnormality is found, stop the machine immediately to find out the cause, and then restart it after troubleshooting.
The daily maintenance of the volute dewatering screw press, since the volute sludge dewatering machine was applied to the field of sludge dewatering treatment, it has gradually replaced the plate frame with its advantages of no clogging, energy saving, low operating cost, long service life, and simple operation. Sludge dewatering machine, belt sludge dewatering machine. It has been widely used in municipal sewage plants, printing and dyeing, paper making, food, breeding, chemical industry and many other industries. Although the screw stacker sludge dewatering machine has a low failure rate and can run smoothly for ten years, the operator must also do a good job in the daily inspection and maintenance of the screw stacker to ensure that the equipment can achieve high efficiency and effective dehydration. And prolong the service life of the screw stacker and supporting equipment. The daily maintenance of the stacked screw sludge dewatering machine is mainly to carry out the daily inspection and regular inspection of the equipment. It is an important task to ensure the normal operation of equipment to grasp the status of equipment in time, discover and eliminate hidden dangers of equipment in time through inspection, and prevent sudden failures and accidents.
The daily inspection is that the operator checks the technical status of each part of the equipment according to the prescribed standards, so as to find hidden dangers in time and take countermeasures. Mainly check the following aspects: whether the motor is running normally, whether there is abnormal noise, and whether there is vibration. Whether the set gap is appropriate for the pressed plate, and whether the moisture content of the dewatered cake changes too much. Whether the solid content of the filtrate of the snail body is abnormal. Whether there is sludge accumulation around the return pipe of the metering tank. Whether the flocculation mixing tank forms a suitable alum flower.
https://www.biocell-enviro.com/
